High-stability turbine and compressor lubricants engineered for rotary screw, reciprocating, and vane air compressors with low carbon deposit tendencies.
Direct factory supply in barrels, drums, buckets, and cans
ISO VG 46 / DIN 51506 VDLWintex Turbo-Guard 46 is a high-performance compressor and turbine oil with exceptional oxidation stability and anti-foam characteristics. Formulated for rotary screw compressors, reciprocating compressors, and steam/gas turbine bearing lubrication. Extended drain intervals of 6,000+ hours.
Key recommendations from our lubrication engineering team
Optimized for oil-injected rotary screw compressors, ensuring rapid heat transfer, low rotor friction, and clean separator filters.
Higher viscosity grade providing heavy cylinder film strength and valve protection in multi-stage reciprocating compressors.
Enables rapid separation of compressed air moisture in condensate traps, preventing water recirculation through air ends.
Answers to common questions about compressor & turbine oils selection, storage, and compatibility.
When compressed air heats up above 100°C, unstable oils degrade into hard carbon deposits on exhaust valves. These hot spots can ignite oil vapors. Wintex Turbo-Guard uses highly refined base stocks that resist carbonization.
Under standard operating conditions (discharge temp < 90°C), Wintex Turbo-Guard 46 provides up to 4,000 hours of continuous service. Reciprocating units typically require drain intervals of 1,000 to 1,500 hours.
